He is a hired patrimony administrator within the Technical Service of the Communication Center of the GHEORGHE ASACHI Technical University from Iasi and graduated student of the forth year at the Faculty of Material Science and Engineering, in the specialty Materials Processing Engineering, with the average 8.30, which bought him a mention award. Under the scientific guidance of the project director he will elaborate in 2008 the graduation paper entitled Use of shape memory alloys as thermal sensors in hydraulic installations . He took part to the section Mechanisms within the Scientific Student Communications, in May 2005, being rewarded with a mention award.
Within the project he is involved in the following activities (according to section 12.1. Workplan. Objectives and activities, Annex 5) :
In 2007: 1.2 Dosing the chemical composition; 1.3 Crucible selection and 1.4 Ingot elaboration.
In 2008:1.1 1.1 Determining chemical composition; 1.2 Quantitative and qualitative analysis of metallographic structure ; 1.3 Determining critical temperatures; 1.4 Determining tensile behavior; 3.2 Quantitative and qualitative analysis of metallographic structure; 3.3 Determining critical temperatures; 3.4 Determining tensile behavior; 3.5 Analysis of constrained recovery SME; 4.1 Analyzing the content and sending the acceptance for contributions ; 4.2 Editing workshop proceedings
In 2009: 2.1 Quantitative and qualitative analysis of metallographic structure; 2.2 Determining critical temperatures; 2.3 Determining tensile behavior; 2.4 Analysis of constrained recovery SME; 4.1 Quantitative and qualitative analysis of metallographic structure; 4.2 Determining critical temperatures; 4.3 Determining tensile behavior; 4.4 Analysis of constrained recovery SME; 5.1 Analyzing the content and sending the acceptance for contributions ; 5.2 Editing workshop proceedings
In 2010: 1.1 Determining the constructive shapes of coupling/ fixing elements; 1.2 Inducing by machining the determined shapes; 1.3 Welding the coupling/ fixing elements; 2.2 Hydraulic test of the coupling; 2.4 Writing the annual self-evaluation report |
Română
